Courtesy of Fred Hibbert, REALTOR®

What Your Home Inspection Should Cover

Siding: Look for dents or buckling

Foundations: Look for cracks or water seepage

Exterior Brick: Look for cracked bricks or mortar pulling away from bricks

Insulation: Look for condition, adequate rating for climate (the higher the R value, the more effective the insulation is)

Doors and Windows: Look for loose or tight fits, condition of locks, condition of weatherstripping

Roof: Look for age, conditions of flashing, pooling water, buckled shingles, or loose gutters and downspouts

Ceilings, walls, and moldings. Look for loose pieces, dry wall that is pulling away.

Porch/Deck: Loose railings or step, rot

Electrical: Look for condition of fuse box/circuit breakers, number of outlets in each room.

Plumbing: Look for poor water pressure, banging pipes, rust spots or corrosion that indicate leaks, sufficient insulation

Water Heater: Look for age, size adequate for house, speed of recovery, energy rating.

Furnace/Air Conditioning: Look for age, energy rating. Furnaces are rated by annual fuel utilization efficiency; the higher the rating, the lower your fuel costs. However, other factors such as payback period and other operating costs, such as electricity to operate motors.

Garage: Look for exterior in good repair; condition of floor—cracks, stains, etc.; condition of door mechanism.

Basement: Look for water leakage, musty smell.

Attic: Look for adequate ventilation, water leaks from roof.

Septic Tanks (if applicable): Adequate absorption field capacity for the percolation rate in your area and the size of your family.

Driveways/Sidewalks: Look for cracks, heaving pavement, crumbling near edges, stains.

www.REALTOR.org/realtormag Reprinted from REALTOR® Magazine Online by permission of the NATIONAL ASSOCIATION OF REALTORS® . Copyright 2003. All rights reserved.